Skip to content

Ball

Ball makes a smooth sphere of the Radius you set, resting on the ground. Turn Spherical off and Stretch X, Y and Z appear: each multiplies the radius along its axis, so 1 leaves it, 0.5 flattens it and 1.5 pulls it into an egg. The ball is built from four-sided faces with no pole, so Subdivide, Loop Cut and Noise all work on it cleanly, and it shades smooth even with few segments. It has no UVs; add Smart UV or Auto Unwrap before painting it.

Segments is the number of cuts across each face of the cube the ball is built from, so the ball has 6 × Segments² faces: 8 gives 384, 16 gives 1536. The default of 8 reads round at the usual sizes. Raise it when the ball will be roughened by Noise or cut by Boolean, since those need points to move; a value of 1 is a cube with its corners on the ball.

With Pivot on Bottom (the default) the lowest point of the ball sits at the origin, so it rests on the ground next to a Box and a bigger Radius lifts its center. Center puts the middle of the ball at the origin.

None. This node creates new geometry.

Mesh

A new ball mesh of four-sided faces with no pole, smooth-shaded, without UVs.

Parameter What it does Default
Radius How big the ball is, from its center to its surface. 25 cm
Spherical Keep the ball a true sphere, or stretch it per axis. On
Stretch X Multiplies the radius along X (1 = unchanged). Shown when Spherical is Off. 1
Stretch Y Multiplies the radius along Y (1 = unchanged). Shown when Spherical is Off. 1
Stretch Z Multiplies the radius along Z (1 = unchanged). Shown when Spherical is Off. 1
Segments How finely the ball is cut. More cuts give a rounder silhouette and later nodes, such as Noise, more points to move. 8
Pivot Where the ball sits: resting on the ground, or centered on the origin. Options: Bottom, Center Bottom
  • Box: a box with its own width, height and depth.
  • Blockout: build a shape from several solids.
  • Noise: rough up a dense ball into a boulder.
  • Create nodes: the other nodes that make geometry from nothing.